Abstracts Engineering

Establishing a facility to measure packed column hydrodynamics

by Sarel Marais Lamprecht

Thesis (MScEng (Process Engineering)) – University of Stellenbosch, 2010. ENGLISH ABSTRACT: Distillation continues to be the most widely used method of separation in the processing industry, in spite of its inherently low thermodynamic efficiency. Two of the critical distillation research needs that arose from the US-Initiative Vision 2020 were to develop a better understanding of the physical phenomena as well as developing better predictive models. Also, characterisation of modern packing materials is required to assist in the CO2 capture optimisation. This thesis deals with both these aspects by establishing a facility that can accurately measure the hydraulic capacity of packed columns. This setup eliminates mass transfer and specific attention can be given to the hydrodynamic behaviour of packed columns. Two phenomena that have a large impact on the mass transfer efficiency of packing materials are the loading and flooding point. The loading point is signified by the following: a.) where the packed column hold-up increases, b.) higher increase in pressure drop, and c.) a decrease in Height Equivalent to a Theoretical Plate (HETP). The onset of flooding is where the shear forces between the gas and liquid become so large (relative to the gravitational forces) that a net upwards movement of liquid occurs, resulting in liquid droplets being heavily entrained. This is normally accompanied by a sharp increase in HETP, pressure drop and liquid hold-up. The prediction of these operating limits is of great value but, despite the many contributions that were made from 1960 to 2010, there is still room for improvement. The operating region of particular interest is between the loading and flooding point, especially for fluids with physical properties significantly different from that of water. In the past, this operating region was not of great importance, but industries are constantly striving to increase their production with minimal capital expenditure. Thus, packed columns are being pushed to their limits and a good understanding of the phenomena occurring near these operational limits is now required. A 400 mm diameter glass packed bed setup (with a bed height of 3000 mm) was designed and constructed to test the effect of the following parameters on packed bed pressure drop and liquid hold-up: · Gas and liquid physical properties · Gas and liquid rates · Type of packing (either random or structured) The experimental setup has been designed so that in the future the influences of the above mentioned parameters on entrainment can also be measured. Initially, hydrodynamic tests on random packing materials (1.5” Pall® Rings, 1.5” IMTP®, 1.5” Intalox® Ultra™) were conducted over a liquid range of 6 - 122 m3/(m2·h). Through a thorough literature study it was found that the most likely semi-theoretical model, that would be able to predict the pressure drop and the liquid hold-up over most of the random packing test range, was the model developed by Billet [1991; 1993; 1995; 1999]. The…